![]() ![]() Again, you only need to map one linkage group. I have listed the first three markers from the output of that "Group" command. These are assigned based on the "Group 3 30" command you execute for this dataset. The linkage group you are to map is listed below. That analysis, you are only required to map one linkage group. (arab2.raw) are of increasing complexity (and therefore of different point value).ĭataset four (arab2.raw) is a complete set from an Arabidopsis mapping project. Datasets two (beanbc.raw), three (arab1.raw), and four You do not need to turn that analysis in. You use the dataset to become familiar with the features of the software. Is the one used to demonstrate the software in class. Below are fourĭata sets for you to analyze using the Mapmaker software. The list above shows the members of your group. ![]() The same groups as you did for you mini-review. Use the instruction on the following link to learn how to run MAPMAKER Mapmaker_DOS_Instructions_and_Assignment.pdfĪlso complete the practice exercise with the arab.raw dataset. Instructions for doing that are available from the following link: Note: You need to download the MAPMAKER software and the datasets that you will be working with. As with all assignments, you will working as groups. 200 points (dataset 2: 30 pts dataset 3: 70 pts dataset 4: 100 pts) PLSC 731 - Homework Assignment: Learning to Use Mapmaker ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |